How to use
Prepared sample with the wide measurement 15 mm and long not less than 20 cm
arranged pressure gauge approximately 5 kgf/m²
pressed power and power printer
pressed the switch yes went out display specimen no..?
Put the figure for the number sample
pressed yes went out display machine no..?
Put the machine numbers
pressed yes went out display the basis weight?
Press the appropriate figure grammature that would be tested
pressed yes went out display direction?
Chose for the testing (MD1, CD2, ND3) and put the number
pressed yes went out display..... (80,100,150,180)
chose and put the figure to long test
pressed yes went out display velocity? ... (20~100)
pressed the figure in accordance with the speed that was wanted
pressed yes went out display confirmation?
Pressed yes when appropriate and
pressed no when not and repeated put the data that needed
put sample sheet by sheet, the implement will go and stopping in an automatically manner
pressed yes for results printer,
Repeated for another sample
finished the testing, pressed no for the calculation of results test
the calculation: kgf = tensile KN/0.65378
Construction
Air chuck, load cell side
Air chuck, tension side
Pressure gauge
Reducing valve
Printer
Load cell amplifier
Display
Ten-key pad
Control box
Output for recorder
No comments:
Post a Comment